MTFCA Forum

Jacob and Scott. The video is a good basic primer showing the simplicity of that particular type pump. Some pumps have leather cups that need to be replaced, I own and have restored several pumps mounted on single, double and triple tanks.. They are simple (or I could not have done them) and if you ...

Wednesday 9 AM I-20 Westbound Weatherford Texas there was a car hauler with a load of T’s—-anybody know where they were headed?

Yes Les--I follow your posts and knew the shaft was of your design.. Thank you and so many others with the talents you and they have.

In answer to Phillips post, I used an original KRW boring jig with false cam and a boring bar I had made some time ago with only one cutter so one does not have to set three cutters as the original. I realized the over cut would widen the journals and thought about correcting this with caps, which i...

Thanks Mark for the link. I had considered this and had fitted a cam with a standard gear as a trial. It went together---very close, with no lash. Thanks to Ashley and two day delivery I have an undersized gear on my bench and will try it tomorrow. Will also copy the measurements in the link furnish...

Bit the bullet the other day and attempted to bore a block for my new Skat crank. The crank that came out of the block was undersized, so I had enough babbitt to bore to 1.250. Making an embarrassing mistake in the cutter setting, I over bored the block resulting in the crank now sitting further up ...

John Snyder

My 14 that I usually drive on tours is equipped with programmable amber strobes purchased from a store that sells first responder equipment. Wired to separate sealed 12 volt battery, Visible from a long way.

Pre War Chickasha is the T meet—Pate not much old stuff