MTFCA Forum

Thank you everyone a bit of research armed with your advice has reveled that the rims I have require a clamping ring that I have been able to source from the same guy I obtained the wheels from but now I have discovered a small rust hole in one of the rims any advice on how I would repair the rim wo...

Sorry for the delay in my reply, Dallas in your photo is there anything held between the wheel felloe and the spit rim by the wheel clamps it looks as if there are several lines or pieces where on the wheels I have there is gap when the rim is placed over the wheel. As always any help is greatly app...

Thanks fellas I assume the rim is split to allow fitting of the tire before clamping the wheel into the rim.

Good morning everyone I have managed to get some rear wheels for my TT, can anyone enlighten me on what I have as the bloke I got them from had no information as he found them and thought they would be a cool garden ornament. DSCN0463.JPG DSCN0462.JPG DSCN0461.JPG DSCN0460.JPG DSCN0459.JPG Would I b...

Finally got them out, it was a battle but all the springs are in reasonable condition.
Thank you all for your replies.

Thanks Dave I’ll keep working the mongrels.

Good morning, I’m attempting to remove the springs from the rear of a TT Ton Truck and have removed the six 1-1/16 crown head nuts from there bolts, the triangular plates and the two U shaped shackles but have not been able to remove the bolts from the frame that run through from the end of each set...

Thanks Chris I thought it was not original.

Good morning can anyone tell me the what front spindles I have in the attached image the bottom one measures 155mm overall inside bearing to end of the thread 30mm inside diameter of inside bearing with a thread 50mm long and 19mm diameter the spindle attached to the body of the axle measures 127mm ...