MTFCA Forum

Hey you hit/miss guys out there, I am looking for a pulley side flywheel for my newly aquired Stover. If anyone has any info/contacts thanks in advance.

Yes I have contacted flywheel supply.

Does your engine have spoked flywheels or the ones with round holes in them?

Pat my flywheels are the round hole style. Any leads on parts would be great, thanks.

I have one complete, running Stover K 1 1/2 and one (Bad) crankshaft with 1 good flywheel. The flywheels on the bad crank both appear the same, and each has the number 12KS2 cast in. These flywheels have no other lettering on them. The complete Stover K has the same type flywheels, but they carry the number 12K2 and have the Stover name and Freeport Ill. cast into them. All these wheels have the circular holes.

There is a Hit and Miss forum there are lots of parts there Russell STOVER is a candy maker and I am going to superimpose the STOVER name on this model K. This is a Canadian model sold by the T EATON Company A long gone Canadian chain. My model K is complete but I have dismantled it for cleaning and restoration. The flywheels are holes and the magneto is the oscillating type that just goes back and forth. I also have a Fairbanks Headless 1917 that runs.

Ah, I remember shopping at Eatons in the 90's during a trip to Vancouver, Canada. I seem to recall it was mostly a clothing type department store then. Another old company bit the dust. Maybe they should have stuck with machinery