Presto-lite tank question

Posts that have nothing to do with the Model T. You can post here or OT posts will be moved here.
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules

Topic author
John Haynes
Posts: 21
Joined: Tue Jan 08, 2019 11:56 am
First Name: John
Last Name: Haynes
Location: Chadron, NE 69337

Presto-lite tank question

Post by John Haynes » Tue Jul 02, 2019 6:21 pm

I am restoring a presto-lite tank and have several questions. I have one with the Presto-Lite" has raised letters. Should this one also have the stencil? Also, how should the outlet be positioned. It is on one side of the tank, should it go on the bottom, top, left or right? I would appreciate the help! Thank you in advance!
John Haynes

User avatar

Rich Eagle
Posts: 1487
Joined: Fri Jan 04, 2019 10:51 am
First Name: Richard
Last Name: Eagle
Location: Idaho Falls, ID
MTFCA Number: 1219
Contact:

Re: Presto-lite tank question

Post by Rich Eagle » Tue Jul 02, 2019 11:42 pm

The raised letters were a later addition and no stencil was used. The valve should be as high as possible so only gas comes out of the cylinder. Some frown on them being mounted horizontally rather that vertically as used for welding.
This discussion shows some installed. Also a decal on the later one but the only one I have seen that way.
http://www.mtfca.com/discus/messages/50 ... 1442783995
When did I do that?


Grizwaldo
Posts: 71
Joined: Tue Jan 08, 2019 7:01 pm
First Name: Steve
Last Name: Grisbee
Location: Cheyenne

Re: Presto-lite tank question

Post by Grizwaldo » Fri Jul 26, 2019 9:36 pm

Part of the acetylene producing process inside the tank uses acetone. Like Rich says,you want that valve up as far as possible to let the gas out but keep the acetone from running into the hose.

Post Reply Previous topicNext topic