Haven’t posted progress in a while
Posted: Tue Feb 11, 2020 10:39 pm
Here are some pictures of progress on my 22 center door sedan.
MTFCA Forum
Model T Ford Club of America
https://mtfca.com/phpBB3/
Haven’t posted progress in a while
Page 1 of 1
Re: Haven’t posted progress in a while
Posted: Tue Feb 11, 2020 10:41 pm
More pictures
Re: Haven’t posted progress in a while
Posted: Tue Feb 11, 2020 10:44 pm
My basement is a gathering of sub-assemblies. I also have both front seat platforms, the cowl former, windshield header and a kit for the roof rails/bows.
At least one other piece will need to be made and that’s the rear seat stringer. I may also need to rework the front header as it has a significant bow to it (I’m fairly sure it should be flat.)
The hardest piece for me to make was the steering column bracket.
At least one other piece will need to be made and that’s the rear seat stringer. I may also need to rework the front header as it has a significant bow to it (I’m fairly sure it should be flat.)
The hardest piece for me to make was the steering column bracket.
Re: Haven’t posted progress in a while
Posted: Wed Feb 12, 2020 5:49 pm
Happy to see progress!
Re: Haven’t posted progress in a while
Posted: Wed Feb 12, 2020 8:41 pm
Thanks much!
Re: Haven’t posted progress in a while
Posted: Wed Feb 12, 2020 11:31 pm
Wonderful photos Will!
I think my late, very sad, Center Door has that column bracket. I gotta go look tomorrow!
Interesting!
I think my late, very sad, Center Door has that column bracket. I gotta go look tomorrow!
Interesting!
Re: Haven’t posted progress in a while
Posted: Thu Feb 13, 2020 9:01 am
Slow and steady wins the race. Keep it up!
Re: Haven’t posted progress in a while
Posted: Sun Feb 16, 2020 5:59 pm
Here’s a tenon that I installed where it should be. The pillar had been sawn even with the sheet metal.
Also filling and reshaping a small missing piece
Also filling and reshaping a small missing piece