Page 1 of 1
Pic of key please?
Posted: Fri Oct 09, 2020 8:53 pm
by Jonah D'Avella
I have a toolbox that I got from luray and I was wondering if anyone had a picture of the key that would fit it. I am able to make my own key if I get a a picture of the key.
Re: Pic of key please?
Posted: Fri Oct 09, 2020 10:05 pm
by Steve Jelf
There's a huge variety of boxes and keys. You're unlikely to find a picture of the right key for your box. I would take it to a locksmith to see if you can have a key made.
Re: Pic of key please?
Posted: Fri Oct 09, 2020 10:16 pm
by Wayne Sheldon
Some of those boxes use a key similar to an old suitcase key. Simple, flat, and only one tooth. Anyone of average DIY skills could make one with a little trial and error. A good locksmith might even have a ready made one hanging on a hook just waiting for you.
Some of those tool boxes need a special key. Still simple by key standards, but more complicated with maybe a hollow shaft, and two or three different height teeth. Those may require a locksmith to make one.
Re: Pic of key please?
Posted: Sat Oct 10, 2020 12:41 am
by TRDxB2
Couldn't tell exactly what tool box you have from the picture - have seen many similar
Here are some previous MTFCA discussions about tool box keys. Hope it helps
http://www.mtfca.com/discus/messages/11 ... 1269874297
http://www.mtfca.com/discus/messages/11 ... 1288995317
Re: Pic of key please?
Posted: Sat Oct 10, 2020 1:16 am
by Erik Johnson
Re: Pic of key please?
Posted: Sat Oct 10, 2020 1:42 pm
by Jonah D'Avella
I made a working key! Thanks MTFCA!