MTFCA Forum

Will there be someone there adjusting coils on sight?

I'd bring my ECCT and let anyone use it for free....but I'm pretty sure my spot won't have electricity access.

One thing to consider if coil adjusting at Chickasha is successful; be prepared to tightly wrap each coil in a sleeve of cardboard that extends above the coil points to protect them from getting bumped in transit home and observe care during coil box installation or all the effort is for naught.

Coil points are much more vulnerable to misalignment than most folks are aware. Properly adjusted coils must be handled and installed carefully following adjustment.

Here are the dimensions for making the protective cardboard sleeves: Secure with packing tap on Side, Top and Bottom. Will ensure save for shipping or transport without risk of detuning.

Very Valuable Information

Thanks Mike

Good ideas, thanks Mike.

FWIW, I will have my coil test equipment at my spaces. NF 9 & 10.

I will stop and see you R.V.

I need to load up my whole car and bring it so you can look at the generator R.V. Anderson.

You rebuilt mine for me about a year ago and I can't get it to charge correctly.

Don, I don't rebuild generators; could you be thinking of Ron Patterson? I buy rebuilt generators from him. Wonderful work.

I need to load up my whole car and bring it...

A few years ago I brought mine just to have Mike Bender drive it and listen to it.

R.V.Anderson wrote: ↑

Wed Mar 10, 2021 2:52 pm

Don, I don't rebuild generators; could you be thinking of Ron Patterson? I buy rebuilt generators from him. Wonderful work.

Yes...sorry...old age kicking in at 52

Steve Jelf wrote: ↑

Wed Mar 10, 2021 3:45 pm

I need to load up my whole car and bring it...

IMG_0680.JPG
A few years ago I brought mine just to have Mike Bender drive it and listen to it.

I remember that Steve. I saw you and Mike leaving the barn in it.