Page 1 of 1
Bore Spacing Model T & A
Posted: Tue May 24, 2022 2:00 pm
by henryford2
What is the bore spacing for the T engine as well as the Model A. Searched but with no avail. Thanks
Re: Bore Spacing Model T & A
Posted: Tue May 24, 2022 3:01 pm
by henryford2
I found the Model T at 4 1/8", 5 1/4" & 4 1/8" what is the Model A spacing? Thanks
Re: Bore Spacing Model T & A
Posted: Wed May 25, 2022 1:50 pm
by henryford2
Sure would like to "Confirm" the Model A spacing. Searched the MAFCA and couldn't find it. Thanks
Re: Bore Spacing Model T & A
Posted: Wed May 25, 2022 8:09 pm
by TXGOAT2
I had a naked A block, but I gave it to a friend. I have an A that needs the head pulled, but the *&(*&^% thing is tightly stuck. I'm going to have to buy a puller, and I can only hope that will get it off. It's probably been on the engine since 1930. Ford drawing A-6015 might have the information.
Re: Bore Spacing Model T & A
Posted: Wed May 25, 2022 9:29 pm
by Dave Sullivan
I got it at 4-1/4, 5-5/16, 4-1/4 Old blind guy with stanley tape, that close enough?
Dave in Bellingham, Wa.
Re: Bore Spacing Model T & A
Posted: Thu May 26, 2022 6:52 am
by henryford2
close enough for what I need, thanks!