Mezger hinge bolts
Posted: Sun Dec 04, 2022 2:15 pm
Made new Mezger Automatic hinge bolts. The originals had too much clearance.
Page 1 of 1
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 2:34 pm
Not sure what you were worried about, the hex looks pretty good from here… Nice job Richard!
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 2:46 pm
Very nice. It's fun to see those hinges too.
Rich
Rich
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 4:25 pm
Can I buy your old ones?
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 4:34 pm
Are these used on a Model T? I have never seen them on one.
Norm
Norm
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 8:24 pm
Mezger windshields were used on early brass T s. For sure 09 but don't know what years after that. I'm keeping the originals.Thanks Kevin, I made them by turning, then threading the end of the rod to accept a 3/8 nut with the right size hex. I installed the nut, loctitred it down and cut rhe hex on a mill drill using the nut to guide the cuts.
Re: Mezger hinge bolts
Posted: Sun Dec 04, 2022 8:33 pm
Where there’s a will, there’s a way! Way to go!