MTFCA Forum

Posted: **Sat Dec 09, 2023 1:27 pm**

Hello,

I have a 26 engine that has an original Bosch front plate 448 distributor. The car has always been very hard to start and I am trying to verify the basics. Could someone confirm install instructions on an original Bosch 448? I currently have TDC identified, points are open but the rotor is pointing to the passenger side fender. I read the rotor should point to the #1 cylinder. Also, this distributor has a thumb screw on the opposite side of the coil wire. Is this intended to have a ground wire or strap attached?

Thanks!

Posted: **Sat Dec 09, 2023 2:02 pm**

Think the pages may b in reverse order

Posted: **Sat Dec 09, 2023 2:09 pm**

That’s great, thanks for the doc!

Posted: **Sat Dec 09, 2023 3:31 pm**

Instructions were great, set up as described and added the ground wire as instructed. It did start, but I am having a rpm surging at idle. I am running a Winfield sr downdraft. Any thoughts on the source of this? Intake gasket and carb gasket have been replaced…

Posted: **Sat Dec 09, 2023 5:43 pm**

Fisher400 wrote: ↑
Sat Dec 09, 2023 3:31 pm
Instructions were great, set up as described and added the ground wire as instructed. It did start, but I am having a rpm surging at idle. I am running a Winfield sr downdraft. Any thoughts on the source of this? Intake gasket and carb gasket have been replaced…

: 45243.gif (77.88 KiB) Viewed 590 times

--
Instructions in the PDF first page below
-

2104WinfieldSR.pdf: (374.83 KiB) Downloaded 36 times

--
--
Think this Winfield

MTFCA Forum

Bosch type 448 distributor set up

Bosch type 448 distributor set up

Re: Bosch type 448 distributor set up

Re: Bosch type 448 distributor set up

Re: Bosch type 448 distributor set up

Re: Bosch type 448 distributor set up