Page 1 of 1
Jan/Feb Vintage Ford mag
Posted: Sat Feb 10, 2024 3:40 pm
by Dennis Prince
I am wondering if you have gotten you Jan/Feb vintage Ford and if so how do I check to make sure that my dues are current so I can get mine too? Thanks
Re: Jan/Feb Vintage Ford mag
Posted: Sat Feb 10, 2024 7:33 pm
by TWrenn
Dennis Prince wrote: ↑Sat Feb 10, 2024 3:40 pm
I am wondering if you have gotten you Jan/Feb vintage Ford and if so how do I check to make sure that my dues are current so I can get mine too? Thanks
Try contacting the museum office about your dues. I got my issue. How do you think you paid? Check back with that method and see.
Re: Jan/Feb Vintage Ford mag
Posted: Sat Feb 10, 2024 7:50 pm
by speedytinc
Dennis Prince wrote: ↑Sat Feb 10, 2024 3:40 pm
I am wondering if you have gotten you Jan/Feb vintage Ford and if so how do I check to make sure that my dues are current so I can get mine too? Thanks
I thought the same. Called last week.
They confirmed my dues were paid & the magazine was running late.
Re: Jan/Feb Vintage Ford mag
Posted: Sun Feb 11, 2024 1:37 am
by DHort
Both of my magazines arrived around Jan 15th. Does your postal person like reading about Ford Model T's? You should have it by now.
Re: Jan/Feb Vintage Ford mag
Posted: Sun Feb 11, 2024 8:23 pm
by Keith Daniels
I just sent them an e-mail a little bit ago. I can't find my card with member expire date, or does MFTCA just do all renewals on 1/1?
Re: Jan/Feb Vintage Ford mag
Posted: Sun Feb 11, 2024 9:37 pm
by DHort
The sheet of paper that comes with your magazine has your expiration date on it. It is not the same for everyone.
Re: Jan/Feb Vintage Ford mag
Posted: Mon Feb 12, 2024 11:43 am
by RalphS in NE Oregon
Dennis, Hope you get it soon, as your car is pictured on page 32 out on the Darby Trail in Idaho.
Re: Jan/Feb Vintage Ford mag
Posted: Mon Feb 12, 2024 11:51 am
by TWrenn
RalphS in NE Oregon wrote: ↑Mon Feb 12, 2024 11:43 am
Dennis, Hope you get it soon, as your car is pictured on page 32 out on the Darby Trail in Idaho.
Here it is Dennis!
I had to trim the page pic in order for the website to accept it.