Page 1 of 1
Help contacting Bill Barth
Posted: Mon Jan 27, 2025 10:54 pm
by ModelTWoods
Is Bill Barth (who made Stewart speedometer parts) still with us? If he is, does anyone have his contact information?
Re: Bill Barth
Posted: Tue Jan 28, 2025 6:25 am
by Jerry VanOoteghem
Posts that simply begin with a person's name usually suggest bad news. Yes, Bill is still with us. He lives in Colorado. I'm not aware of his ever making speedometer parts, however, but he's a very resourceful guy, so maybe he has.
Re: Bill Barth
Posted: Tue Jan 28, 2025 12:36 pm
by ModelTWoods
Jerry, I apologize for just posting his name. I agree with you that I should have said "Searching for Bill Barth" or something like that. In a old Forum post, it was mentioned that he lived in Trinidad, CO. and had made some replacement parts for the Stewart 490 speedometer, or for its drive. That is the reason for my interest. The only address that I have found for him is: 320 S. Main, Trinidad, CO. If anyone has a confirmed current address, please post it.
Re: Bill Barth
Posted: Tue Jan 28, 2025 5:23 pm
by Jerry VanOoteghem
Terry,
PM sent.
Re: Bill Barth
Posted: Tue Jan 28, 2025 5:58 pm
by Joe Bell
I have a boat tail speedster that has is name on the back of it, along with Jerk Reitsma and a few others.
Re: Bill Barth
Posted: Tue Jan 28, 2025 8:21 pm
by ModelTWoods
Jerry, I haven't seen a PM or email. Could you resend using email?
Re: Bill Barth
Posted: Wed Jan 29, 2025 6:19 am
by Jerry VanOoteghem
ModelTWoods wrote: ↑Tue Jan 28, 2025 8:21 pm
Jerry, I haven't seen a PM or email. Could you resend using email?
Email sent.
Re: Bill Barth
Posted: Wed Jan 29, 2025 11:50 am
by DHort
Terry
I believe you can still change the title of your post. That way others will not assume Bill is deceased.
Re: Bill Barth
Posted: Wed Jan 29, 2025 12:39 pm
by Jerry VanOoteghem
ModelTWoods wrote: ↑Tue Jan 28, 2025 8:21 pm
Jerry, I haven't seen a PM or email. Could you resend using email?
Did you eventually get my email?