? re: Bolts to hold engine pan to frame
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Topic author - Posts: 2477
- Joined: Sun Jan 06, 2019 1:30 pm
- First Name: Dave
- Last Name: Hjortnaes
- * REQUIRED* Type and Year of Model Ts owned: 24 Speedster, 20 touring
- Location: Men Falls, WI
- MTFCA Number: 28762
- MTFCI Number: 22402
? re: Bolts to hold engine pan to frame
The wood blocks are in place. The upper bolts are snug. The bolts that run horizontally through the block are suppose to be 2 1/4". That size will be too short. I am going to have to use a 2 1/2" bolt in order to get the nut on and cotter pin in place. Maybe there is an issue with the pan or with the frame, but I have to live with it. Has anyone else had this issue?
Re: ? re: Bolts to hold engine pan to frame
When I put those in my 26 Roadster I had to cut the nut down to get the pin to go. That bolt doesn’t get tightened so it wasn’t a problem to cut it.