MTFCA Forum

Can anyone tell me which of the pullers in this pic is a T hub puller. Maybe they both are. How much of this tool collection is Model T? I have a chance to buy them all but mostly concerened about the pullers.

The hub puller on the right looks like T.
Got any measurements ?
The T handle wrench may be wire wheel Lug nuts.

The hub puller on the right is a T hub puller. I have one just like it. It has the Ford script on it. Not sure if the other one is T. If it’s a
Ford puller it should have Ford script on it I would think.
Model T tool “sets” show up from time to time with period correct tools but not necessarily a Ford tool set. Some of the tools may not be Ford branded in this group.

I'm seeing some T, TT, A, V-8, possible Ford Tractor & Walden-Worchester.

Check the threads in the pullers. Very few cars had the fine threads that Henyy used on his hubcaps. Of the wrenches on the right, the third one down is a TT plug and wheel nut wrench. The next is an earlier incarnation of the same tool for a T. The flat 4 hole piece is a T hubcap and other wrench. Of the open end spanners, the top one looks like a T1917 band adjusting tool. That very lightweight end is only to be used on the spring loaded nut inside the transmission on the reverse and brake bands on a LHD car.

I may have missed some.
Allan from down under.

I did miss the Ford script pliers. They are T model. The adjustable wrench with the square end was introduced with the 26-7 model Ts. The square end fits the diff filler plug This same tool carried over into the A model era.

Allan from down under..

If you flip over the T combination wrench, I believe you will notice the 2 upsets opposite each other for the front wheel bearings - that's intended for Ford wire wheel front hubs.

I found this in doing a search.

Thanks for posting that. I have a very nice puller that does not fit T or TT. Maybe this will help.