MTFCA Forum

So a while back I posted a request for NH rebuild tools, of course Scott Conger responded, (Thanks Scott). But yesterday I received an email from Colleen Winchester saying she had the rebuild tools as well for only $80. After a couple of questions I could quickly see where this was going, normally I am pretty busy, but I thought I would engage. Long story short, if any of you need an 11/64" socket to remove the Turbo Encabulater Valve, in the 1934 and later NH carburetor she has one. She does not have a socket to remove the earlier non turbo Encabulator Valve in the NH carburetor.
Good luck, and caveat emptor!
It was fun while it lasted, still looking,
Kevin

I see now that I'm selling my stuff too cheaply

Well, if she's going to get anywhere selling sockets to remove turbo-encabulator valves, she needs to be sure and include a reciprocating Dingle arm to reduce sinusoidal depleneration. Otherwise, the deal is off!

Every WTB post I make is answered by a scammer. First thing I do is look at their posts and join date. It is usually a recent join date and only a very few posts. I report them to the Admin. Art

You want to be SURE that you get a Left Handed One!! That is another trouble point!

You want to be SURE that you get a Left Handed One!! That is another trouble point!

Fortunately, I have a FULL set of "Foonman Wrenches", that I obtained when a relative was finally committed.