Tomorrow’s project
Posted: Tue Nov 26, 2019 11:04 pm
Page 1 of 1
Re: Tomorrow’s project
Posted: Tue Nov 26, 2019 11:32 pm
I have to do that, but I only have one. 
Re: Tomorrow’s project
Posted: Wed Nov 27, 2019 10:18 pm
At $125 for the bell housing I will take time and repair them.
Face plate made for boring & machining once I silver solder in an incert. Think that will work?
Face plate made for boring & machining once I silver solder in an incert. Think that will work?
- Faceplate done
Re: Tomorrow’s project
Posted: Thu Nov 28, 2019 12:47 am
I do these all the time. I braze them up and rebore them. Most of the time the brass is all gone when they are bored out due to shrinkage as they cool. Dozens of repaired ones out in the road.
Re: Tomorrow’s project
Posted: Fri Nov 29, 2019 12:36 am
Another way would be to step bore them and press a ductile iron insert into the bore from the inside.
Re: Tomorrow’s project
Posted: Fri Nov 29, 2019 10:01 pm
- Finished product
- Finished product
Re: Tomorrow’s project
Posted: Sat Nov 30, 2019 10:08 am
What are they?
Re: Tomorrow’s project
Posted: Sat Nov 30, 2019 10:34 am
Ruckstell bell housings.