Page 1 of 1
Stevens Tooling is In. FS video added
Posted: Thu Dec 29, 2022 4:14 pm
by Dan Hatch
New batch of Stevens Front Axle Tooling is done. Those that pre ordered will be receiving total soon. There are a few sets left, so if you want a set you better jump on these. Due to the price increase there may not be any more.
These are only being sold in sets, one top (tapered) reamer and one reamer/tap (bottom).
Price is $475 for the set + shipping.
Email me at address in pictures. Thanks Dan
Also available will be bronze thrust washers @ $7.50 each.
- Top reamer
- Reamer/tap bottom
- 97C4F6D4-8B70-41B9-8A92-341651BD839B.jpeg (34.02 KiB) Viewed 2185 times
Been ask about thrust washers. They are for protection of the Stevens frame. Here is a picture of where they are used.
Re: Stevens Tooling is In. FS
Posted: Thu Dec 29, 2022 4:54 pm
by Wayne Mims
My name is Wayne Mims I want to set call me I will give you a credit card number and it will be done please my number is 702-354-63 65
Re: Stevens Tooling is In. FS
Posted: Fri Dec 30, 2022 2:43 pm
by Dan Hatch
Wayne: Send me an email to address in pictures. Thanks Dan
Re: Stevens Tooling is In. FS
Posted: Fri Dec 30, 2022 5:50 pm
by FordFool
Dan. I’ll take a set. Let me know the total cost and I’ll send you a check. Don
Re: Stevens Tooling is In. FS
Posted: Sat Dec 31, 2022 3:05 pm
by Dan Hatch
Back to the top
Re: Stevens Tooling is In. FS
Posted: Sat Dec 31, 2022 3:50 pm
by FordFool
Dan am I on your list?
Re: Stevens Tooling is In. FS
Posted: Sat Dec 31, 2022 5:10 pm
by RGould1910
Dan Ill take a set and some inserts. Email sent
Re: Stevens Tooling is In. FS
Posted: Sat Dec 31, 2022 6:56 pm
by Dan Hatch
Don check your email
Re: Stevens Tooling is In. FS
Posted: Sat Dec 31, 2022 9:05 pm
by Dan Hatch
I have gotten some request about how a Stevens Front Axle tool works. Here is a link to me repairing an axle with one. Thanks to Bill for making this available.
https://www.youtube.com/watch?v=7DNGT7P79vg
Re: Stevens Tooling is In. FS video added
Posted: Mon Jan 02, 2023 5:39 am
by Dan Hatch
Back to the top
Re: Stevens Tooling is In. FS video added
Posted: Mon Jan 02, 2023 1:18 pm
by Harry Lillo
Dan,
Thank you for the video.
When you complete the reaming for the cone insert,
do you attempt to leave the top of the cone level with the top
of the axel or just a little proud (above the top)?
Harry Lillo Calgary
Re: Stevens Tooling is In. FS video added
Posted: Mon Jan 02, 2023 2:38 pm
by Dan Hatch
Little above. I am still going to send you the instructions. Just have to scan again, that file got lost. Been too busy to stop and do it. Please be patient with me. Thanks Dan
Re: Stevens Tooling is In. FS video added
Posted: Tue Jan 03, 2023 11:42 am
by Dan Hatch
Back to the top