MTFCA Forum

Hi all - looking to purchase a KRW Driving Plate Bushing Reamer.
I have attached a pic of what I am looking for. Any leads would be be appreciated.

Please email or DM if you can help.

Regards
Simon

More info to help in my quest: KR Wilson reamer marked W-8 sometimes on the square drive end flats. About 13" long; shank 1" Dia.; cutter end reams Driver Plate bushing to 1" I. D. in Model T transmission when bolted to brake drum to ensure positive alignment of all three bushings when rebuilding transmission.

Bump up the list - can anyone help out?

Just in case you’re open to a modern solution

https://drillsandcutters.com/h-hss-adju ... 16-1-1-16/

KRW were not only maker. Here is pictures of my Keystone reamer. Not for sale. But I have thought about having some made. Would not want to think about the cost!

Easy enuf to make. Buy a 15/16" chucking reamer on eBay and make a 1" sleeve to place over the 3/4" shank. Actually .999" per KRW . Best way to do it is make the sleeve a slip fit, then make it a permanent bond with sleeve retainer before turning the OD. Center by indexing off the reamer.

https://www.ebay.com/itm/351532060555?m ... media=COPY

Have parts on order to make one. Will post results if there is an interest

RGould1910 wrote: ↑

Sun Mar 05, 2023 10:41 am

Have parts on order to make one. Will post results if there is an interest

Please do and if you want to make two I would be interested

Open to any brand reamers that would do this job? Message me if you can help me out