MTFCA Forum

I am needing a good steering column shaft for my 26 Coupe. The vendors are all out of stock. Does anyone have a new one lying around or, a good used one that you are willing to sell? Or even a complete steering column with a good shaft.

I have a good used one + gears…..pm me to talk. Jeff P. in MN

I sent you a PM.

Hi Scott,
I sent a PM yesterday and an email w/ pictures just now.
Thanks, Jeff P.

Still looking.

How do you determine if the shaft is for 26-27 and not 12-25?

also show the difference of the franme bracket 26-27 from the 12-25.

The 26-27 is a 5 to 1 ratio. The top of the shaft where the gears and pins go should have a 5 stamped into it. The hole spacing is different than the earlier 4 to 1 type. I believe that all of the reproduction shafts are 5 to 1. The 26-27 column has a square mounting plate where if bolts to the cowl. Here are pictures form Lang's website of the 26-27 box. I am not sure of the difference. I think maybe it mounts at a different angle.

The earlier steering bracket is quite a bit different in design.