MTFCA Forum

Anyone happen to have one or a pair of these ? They were supplied with the accessory Bennett Brake Kit.

I am trying to picture where that part might fit.
https://www.mtfca.com/discus/messages/2 ... 1203700450

They attached around the h.b. cross shaft then over to a hogshead bolt - I have a photo somewhere around here showing them installed ! They were a "stiffener" to prevent the cross shaft from flexing.

Thanks for the reminder. Forgot all about them, not very common. Think one of my friends has them on their car but has been a while since I looked under the floorboards. Theirs may be home made. ?
You might add a photo of it from the side.
Mark

Mark Gregush wrote: ↑

Thu Feb 29, 2024 12:24 pm

I am trying to picture where that part might fit.
https://www.mtfca.com/discus/messages/2 ... 1203700450

You did

Thanks for the additional photo Frank !