MTFCA Forum

Wanted to buy. Tubular exhaust header for flathead T engine. Chickasha PU preferred. Steve 701 212 5009.

Got your email. Sorry can’t help you.
Mike Bender

Steve, You're probably going to have to make your own, or have someone make one for you, UNLESS you can find someone who will part with their header, and even then it may, or may not, fit or be to your liking. If you decide to make your own. I have one of the "make your own" header plates that vendor's used to sell, but isn't sold anymore. The one they sell now is an adapter plate from a T block to an A intake manifold.

got10carz wrote: ↑

Wed Mar 06, 2024 9:38 pm

Wanted to buy. Tubular exhaust header for flathead T engine. Chickasha PU preferred. Steve 701 212 5009.

Here are some ideas from a previous discussion
Some flanges available but not as thick --
-- --
--
Lake style header - buy and make two, sell one
Older add from Speedway --
--
I've wondered if this Model A would work - not sure if the kit is still available but they also weld & fabricate
https://www.hellsgatehotrods.com/shop/f ... eader-kit/

Red's Headers in California, at one time made a bolt on header specifically for T engines, but discontinued them due to low sales and demand. They still make A and flathead headers. I inquired about the T headers a year or two ago, and they didn't give me much hope of ever seeing new production.

Since the suppliers sell and adapter plate to fit the Model A intake & exhaust to a Model T. I would expect that the Model A/B key above would work.