Page 1 of 1
Valve tools FS
Posted: Sat Jun 01, 2024 3:29 pm
by Dan Hatch
Found these in a bucket of stuff. $7.50 + shipping for the pair. Email me at address in the pictures. Thanks Dan
- IMG_0260.jpeg (38.12 KiB) Viewed 1101 times
Re: Valve tools FS
Posted: Sat Jun 01, 2024 3:42 pm
by Karl Von Neumann
Are these the ford marked tools?
Re: Valve tools FS
Posted: Sat Jun 01, 2024 4:19 pm
by Dan Hatch
Don’t know I don’t see any.
Re: Valve tools FS
Posted: Mon Jun 03, 2024 8:29 am
by Dan Hatch
Back to the top
Re: Valve tools FS
Posted: Tue Jun 04, 2024 9:51 pm
by Dan Hatch
One time than scrap
Re: Valve tools FS
Posted: Wed Jun 05, 2024 5:42 pm
by Adam
Dan Hatch wrote: ↑Tue Jun 04, 2024 9:51 pm
One time than scrap
Good luck… I’ve probably tossed twenty or so of those in the scrap over the years. Problem is they only work with standard size valve guides that aren’t very worn (very low mileage original engines only) AND will only cut original cast iron seats… and only if they are sharp.
They ARE a nice display item though, and for the price hopefully someone will grab them.
Re: Valve tools FS
Posted: Thu Jun 06, 2024 1:36 pm
by Scott Rosenthal
Thanks Frank. Ship address for the petcock with the "T" handle is
919 Mt. Hope Ave. Cinti, Ohio 45204
Please shoot me your address and total with shipping. Please do not use MTFCA messaging system, as mine either doesn't work or I have screwed something up so that it doesn't work properly.
Regards,
Scott