MTFCA Forum

I have been ask about reproducing my rear cam bushing reaming tool. I will look into it if there is a larger demand. So is anyone interested in getting one? Here is a picture of what I am talking about. I don’t have any idea about cost at this time. Email me or post here if you are interested. Thanks Dan.

Hello Dan,
I have a KRW one I got through Trent Boggess and Don Lang, but I have not used it yet. In the case of the reamer not being sharp enough for the task, will you sell that part separate?
Ken Buhler

Find someone local that can sharpen the reamer. I just had mine done and had another reamer shortened for a spare.

I'd be interested.