Page 1 of 1

FS ECCT - Brand New!

Posted: Sat Apr 26, 2025 1:02 pm
by MKossor
Its that wonderful time of the year again!
Time to test and tune Model T coils for the Summer Touring season.

Learning the art of coil tuning is fun and easy to do with the right tools and videos.
Taking an active roll in how well your Model T runs also adds a very satisfying component to the Model T driving experience.


ECCT - Complete Test Capability: Coil, Capacitor and Magneto Tester - $574.95
Please visit www.modeltecct.com or more information about the ECCT coil tester.
Production Label.jpg

PC Software makes coil testing and tuning much easier and faster (Included)
Advanced Features SW.jpg

Magneto Test Feature insures magneto output is sufficient to properly operate coils (Included)
Magneto Tester GUI.jpg

May Special - FREE 3 in 1 Coil adjusting tools included for the first 5 orders.
(Enter comment tool525 when placing order. Limited time, Limited quantity offer. Good until 5/31/2025 or while quantities last.)
Please visit https://modeltetimer.com/shop/ols/products/ecct-mt-sw to place your order.
3N1_Tool_A.jpg
Disclaimer: ECCT manufacturer, agents and representatives are not responsible for abrupt popularity or sudden increase of new Model T friends following ECCT purchase. ;)

Re: FS ECCT - Brand New!

Posted: Sun Apr 27, 2025 10:46 pm
by Jim11787
Mike will you be at Luray and will,you have timers?

Re: FS ECCT - Brand New!

Posted: Sun Apr 27, 2025 11:22 pm
by MKossor
Unfortunately, no. Can't make Luray this year due to schedule conflict. Great swap meet, people and food. Looking forward to next year.

Re: FS ECCT - Brand New!

Posted: Mon Apr 28, 2025 4:15 am
by TeveS-Nor Cal
Are you going to come out with your hand held/ swap meet coil tester?

Re: FS ECCT - Brand New!

Posted: Mon Apr 28, 2025 4:16 am
by TeveS-Nor Cal
Are you going to come out with your hand held/ swap meet coil tester?

Re: FS ECCT - Brand New!

Posted: Mon Apr 28, 2025 7:37 am
by MKossor
Yes! Prototype circuit boards are due in this week. If all goes well, should have them available late May or early April.

Many great comments and suggestions from the discussion Forum. I was able to incorporate most of the suggestions.