SOLD One Piece Spindle
Posted: Thu Jul 24, 2025 7:01 pm
This has a faint part number 203 and may have an A following. It is in very good overall condition. There is evidence of some brass, probably from fitting a bushing as one hole shows a slight squeeze. The measurements are as below.
Bearing surface - 1.1875
Center mark - 2 3/8" X 2 1/8 from end
Overall length - 4.4315 mm
Bushing holes - .637 mm
Arm bushing length - 1"
Price is $250 plus shipping unless I am convinced it is too much, as I am open to educated opinions.
Bearing surface - 1.1875
Center mark - 2 3/8" X 2 1/8 from end
Overall length - 4.4315 mm
Bushing holes - .637 mm
Arm bushing length - 1"
Price is $250 plus shipping unless I am convinced it is too much, as I am open to educated opinions.