Page 1 of 1
WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Sat Aug 16, 2025 10:09 am
by JTT3
Header says it all. Best John
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Sat Aug 16, 2025 10:42 am
by RGould1910
John, I wonder if you might make one as I did from a 13-14 riveted drag link. Cut off the ends, drill and ream them out, then tap them for the threaded rod. The rod is the easiest part to make.
I found the difficult part was tapping the threads straight but it was all doable.
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Sat Aug 16, 2025 11:43 pm
by JTT3
Richard it may come to that. Thanks for the potential solve.
Best John
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Sat Aug 16, 2025 11:58 pm
by Ken Buhler
I may have some of those if they have threads at both ends.
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Thu Aug 21, 2025 2:45 pm
by RedDogPilot
john i think i have a early tie rid, fine thread. its very nice . dan mari
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Thu Aug 21, 2025 2:48 pm
by RedDogPilot
john , ithink i have one,iwill chech this afternoon. dan mari
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Posted: Tue Aug 26, 2025 12:18 am
by frontyboy
I have one advertised here and some one wanted it. My 'puter died and I lost all email and history including the purchaser's contact information.
I still have a brand new one fine thread with yoke. I can take all photos and measurements. I was told Kim Dobbins made these some years ago.
thnx
frontyboy. 2ho6-919-1949(Seattle)contact me by phone or text.