MTFCA Forum

Want a mag drive complete, don't need the mag. Let me know what you have, scammers need not waist the time, I will be asking for very detailed photos .

frontyboy
2h06-919-1949.(Seattle)

Side drive…? Cross drive…? Generator motor…?

cross drive non generator

thnx

frontyboy(my other speedster is a 1915 t roadster with a dual overhead cam GALLIVAN engine powered.

I wanna see that gallivan!!

Sounds like yur lookin for a Matco or Columbo. None here, but I do have a couple extra 3in1 plates if you wanna run a dizzy

Mark- I have the drive nuts for Matco crossdrives if you need one in the future.
Dan

I have drawings somewhere for the drive shaft and bushing for the MATCO, not sure if they interchange with the Eisemann tho. The 1” rubber hose coupler typical of the MATCO works very well

My Gallivan

Mighty Impressive ! - Dusty

May I ask where you obtained it? Just curious. Not many around.

Was previously owned by Bert Lobberecht (sp.) then Ron Kipling - both from the Greater Seattle area. Was then procured by Jarvis Erikson & then Musolf by a questionable transaction !

questionable transaction?(!)

Ask Musolf about it !

Is Musolf frontyboy?

Ron, there was nothing questionable about it. While everyone was not paying attention I was contacted by Ron Kipling's executor to purchase the majority of fronty race cars plus the Gallivan, and the Riverside Special.

The executor had all cars appraised and priced. I looked the collection over, he asked if I was interested in any one,I and told him I would take them all some 9 or 10 cars plus the Gallivan and the Riverside special mounted on the TT truck. This was all above board approved by the executor and the lawyers, Ron.

All I did was step up write the large check and buy the cars. The only problem was no one else would write the check. The whiners and the rumor spreaders are mad because they lost out. I'm really tired of the accusations it was all done above board and very legal.

As for the Gallivan I sold it to my oldest car friend Jarvis at the exact price I paid for it, which he had for a number of years. We talked one day and he suggested I buy it back which I did at a nice profit for Jarvie.

So Ron I would appreciate you quit spreading rumors about what you do not know now over 10 years old, give it a rest!!

frontboy

There are always two sides to every story !

Not cheap, but if you can’t decide between a water pump, oil pump, or distributor, this is your baby it would look spectacular all dolled up and restored.

https://www.ebay.com/itm/257079460160?_ ... CdZg&pfm=1