MTFCA Forum

I am working on the chassis that I pulled out the the ground/weeds at my late friend's house have am nearly ready to finally start the engine after quite a bit of work getting it unstuck and cleaned up inside and out. It still looks pretty ugly and rusty which I kind of like and I was fixing to order plug wires and a timer wiring harness but honestly I think that that would look too good. The engine is a 16 and I am planning on ultimately going to try to make a driveable chassis right now, probably going for a brass era look. I just wanted to ask if anyone might have a usable but aged and dirty set or wires and a wiring harness laying around that they would part with. I have a new magneto post on it at the moment which stands out so I could probably use a good but ugly one (with screws) to take its place and a oil fill cap of similar condition.

Thanks and God Bless.