These are hand drawn (no AutoCAD when I started) and not “as built”, in other words they’ve never been checked against a finished part for corrections. They are meant to give you a place to start.
I’ve included drawings for the rear main fillet cutter, babbitt pouring rod & fixtures, penning tool, false cam and boring bar. Each sheet is 17” X 22” drawn in pencil.
Included as well are 3 parts of the pouring dams, the more difficult parts to make (I wire cut these parts), and approx. 40 photos of the KRW tools and other examples of babbitt pouring and machining fixtures.
$100 including shipping in the CONUS. It would cost you as much if not more to have the 3 pouring dam parts made.
Contact me through the attached email address and not through the club. Thanks