Post parts wanted or for sale here
- Posts: 268
- Joined: Sun Jan 06, 2019 10:29 pm
- First Name: Richard
- Last Name: Grzegorowicz
- Location: Hartland VT
I KNEW I HAD THIS ITEM , ITS USE FULL WHEN PACKING GREASE IN A WHEEL BERG, YOU STILL GET THE HAND GREASY BUT THE BERG'S GET FILLEDIT WILL PACK A GOOD SIZE BERG. BY PLACING THE WIDE SIDE OF BERG ON BOTTOM OF PACKER AND THREADING TOP HALF DOWN TIGHT MOUNT THE GREASE GUN TO THE FITTING AND PUMP , TO TELL WHEN BERG IS FULL OPEN COVER TO CHECK .IF NOT RE TIGHTEN COVER AND GIVE IT ANOTHER SHOT TILL IT IS, $20 PLUS POST ITS MADE SO YOU CAN REMOVE THE FITTING AND THRED THE GREASE GUN HOSE INTO TOP FITTING FOR A PERMANENT FIXTURE.
- Posts: 133
- Joined: Sun Jan 06, 2019 11:25 pm
- First Name: Jeff
- Last Name: Hood
- Location: Long Beach, CA.
- MTFCA Number: 25636
Both cones should be oriented in the same direction. The bearing gets greased and you can see that the grease has gone all the way through. You don't have to take it apart to see the bearing. Also uses less grease.