MTFCA Forum

Just noticed that my engine oil smells like gasoline. Any ideas? Stock engine.

Thank you all for the information

Here's a silly question, is it possible to remove the driveshaft without removing the engine or rear end? I need to repair the 4th main engine bearing.
Thank you

Thank you all for the info.

My question is, the front springs have a clamp one on each side of the springs under radiator. Are they supposed to be tight? They do move when shaken but they stay in place. They are noisy.

1926 Tudor
Thank you.

Thank you all

How do you remove the cowling fuel cap hinged cover? 1926.

Hi there, I installed new stainless valves and adjustable lifters in my 1926 T. I just put the valve and lifters in and adjusted the valves to .014. Engine starts fine but engine lacks power. Should I have taken head off and re-time valves?

Thank you

dacapt1948 wrote: ↑

Sat Sep 28, 2019 1:09 pm

is track measured from center of tire to other tire center? Also what is a wide track front axle?

What I ment what was a wide track made for and what years?

Thank you all

is track measured from center of tire to other tire center? Also what is a wide track front axle?

I just noticed that my Ruckstell axle width is about 2 inches narrower that my front axle. This is on a 1926 tudor. Question is ,did ruckstell axles come in different widths? My present ruckstell axle has a small backing plate and should have been a large backing plate, which means someone has chang...

Thank you

Hello. I cannot find the fuel capacity of a 1926 Tudor (cowl gas tank) I thought I drained the tank, but when I added fuel it only took 7 gallons of fuel.

no I didn't....Thank you for advice.

Replaced pistons/rings. Now have engine knock when advancing engine timing. Quiet at idle, noise increases when advancing Distributor with advance lever and increasing rpms.