MTFCA Forum

I sent you a private message

I am looking for the side that attaches to the springs. I only need about 8-12" of the gooseneck. I am building a speedster and have built a custom body. I hate to cut a perfectly good gooseneck. I will be fabricating the rest. I don't know if somebody has one in the broken/junk pile. Thanks for loo...

thanks so much

I am working on my '27 Tudor. On the floorboard support angling up at the front, my car has a brass colored rivet on the metal support on each side. Any Idea what this would have been used for?
https://www.mtfca.com/phpBB3/download/f ... &id=180031

Good news. The bolts holding the fender bracket screw into a threaded section attached to the inside of the body. See attached photo. Sorry had to rotate pix to get it to attach

It is time to do some repair on the ford. I need to remove the rear fenders. My question is about the bolts from the bracket into the body. Do these have a nut on the inside? I removed the rear seat bottom but can't see where the bolts come thru. I am hoping that these just thread into the body. I r...

charged magneto in the car and runs great again. Thanks for the help

I suspect the engine got above 176 degrees. I think attempting a magnet recharge sound better than pulling the engine however it may get to that at some point.

After a recent tour I now have very little power from the magneto. The car overheated after the fan belt came off. The car ran great on battery and magneto prior to this. Now several days later it runs great on battery but dies on mag. I have checked the wiring, coil box etc. Tried a magneto test wi...