MTFCA Forum

Trying to see if my re-register works ok.

Hi,
I need to replace the gasket on the carbide generator.
What is the group's consensus on the process, materials, and method?
If you have any best bets, resources or success stories, I'd love to know.

BTW, I repaired my leaks with silver solder! Successfully, but not without trepidation.
Thanks for your advice.

Thank you,
Greg

One of the first things noted is that where on the old I could have maybe 10 lines of post on a smart phone screen before needing to scroll, the new one gives me but one open post (which is OK) until folks go wild with signatures and then I wish I had a thumbwheel.

I found out that if you too have smaller smart phones where you need landscape to...

:D Lets see what happens:

I am registered.

When using the old MTFCA link, (now 'bookmarked' and kept), am finding the previous Forum years going back to 2005 to be accessible. The same link allows the 2019 connection, but then only ID's back to 2018. Since saving many past threads/titles to reference for the expertise and knowledge of others, it is hoped those bits of information are not...

b hguyft7.jpg

This past Saturday marked the 105th anniversary of Ford's $5.00 per day wage...

wage.jpg

snowbank2.jpg

At my age I don't like change but I am very pleased with this new forum. It's quite apparent that a lot of thought has gone into it and I am gratefull.

change.png

I'm about ready to reassemble the rear differential from my 1917 Touring. I'll eventually be filling the differential with APG 140 gear oil but wonder what I should use to pre-lube the inner hyatt bearings prior to installation? I'm tempted to use a light bearing grease but perhaps I should just coat them with gear lube. Comments?

Just got confirmed but already have a question. Will there be a link to the MTFCA home page like there was on the old forum? Will that page be changed as well and also I saw no place to add a profile picture am I missing that. Thanks Chris for all you do. Jim

I don't know where this was taken but thought it might look good on the new forum.

EarlyTxyz99.jpg

Checking out the new forum!

If someone could teach me how to decode these engine block numbers on my ‘14 Touring, I would be mighty grateful.

B18 41414

P1
P2

Thank you,
Greg

Ps. Any comments on my exhaust manifold? It says KOOLER on it. ??

Top of pagePrevious messageNext messageBottom of page Link to this message By Steve Tomaso - Longbranch,WA on Saturday,...

The Toyota Museum in Nagoya has a few Model T's. They used to offer Model T driving lessons a few years ago but cancelled them due to a lack of interest.

If you're ever in Nagoya and have a bit of spare time it is worth a visit.

Model T Starter.jpg

testing. Looks great.

An interesting option to add foes can be found under your profile settings. I hope to never upset anyone enough to add me. :)

Foes are users which will be ignored by default. Posts by these users will not be fully visible. Personal messages from foes are still permitted. Please note that you cannot ignore moderators or administrators.

Found an already modified '26-'27 touring goose neck tire carrier at swap meet.

Welded on receiver type hitch to the goose neck, and had the proper length to extend past the tire carrier and tire too!
All I had to find was a small size receiver bar, and a tiny hitch ball. The receiver bar needed has to be a dropped style, otherwise the trailer...

I am in! :)

The 2019 Forum is now open.

Please be patient as we make the transition.

I will have to approve everyone as you setup your new user names, sometimes I will not be near my computer but will do the best I can.

Please do not call the office with forum questions for now, post any questions here.

If you can't get on here post on the 2018 Forum, we...