What temp/How long do I heat HDPE pipe and fitting for plastic weld?
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
ivaldes1
Topic author - Posts: 957
- Joined: Mon Jan 07, 2019 1:32 am
- First Name: Ignacio
- Last Name: Valdes
- * REQUIRED* Type and Year of Model Ts owned: 1924 Touring
- Location: Houston, Tx
- Board Member Since: 2016
What temp/How long do I heat HDPE pipe and fitting for plastic weld?
Hi all, I am retrofitting a faulty ground source heat pump system. I have received this new plastic welder from amazon. The sockets appear correct for US pipe (inches not millimeters). The documentation is sparse. What temperature do I set the welder to melt HDPE pipe? How long do I heat at that temperature a 1 inch and 1.25 inch HDPE pipe and fitting before fusing together?
- Attachments
-
- plasticwelder.png (272.04 KiB) Viewed 7810 times
-
ivaldes1
Topic author - Posts: 957
- Joined: Mon Jan 07, 2019 1:32 am
- First Name: Ignacio
- Last Name: Valdes
- * REQUIRED* Type and Year of Model Ts owned: 1924 Touring
- Location: Houston, Tx
- Board Member Since: 2016
Re: What temp/How long do I heat HDPE pipe and fitting for plastic weld?
Seller says for 3 mm wall thickness 230-250 ℃ and a few seconds. Is that about right? Documentation for the tool is sparse.