Valve Lifters
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
vanco
Topic author - Posts: 22
- Joined: Wed Apr 10, 2019 5:58 pm
- First Name: John
- Last Name: Van Cott
- Location: Utah
Valve Lifters
I have a very nice early block with original standard lifters. I have a new set of adjustable lifters that are also marked std. How much clearance should I have using the new lifters? Or would it be best to go to the next size using the proper reamer? Thanks, John
-
Scott_Conger
- Posts: 6523
- Joined: Sun Jan 06, 2019 11:18 am
- First Name: Scott
- Last Name: Conger
- * REQUIRED* Type and Year of Model Ts owned: 1919
- Location: not near anywhere, WY
- Board Member Since: 2005
Re: Valve Lifters
How do the original lifters fit?
Scott Conger
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves™
Obsolete carburetor parts manufactured
Tyranny under the guise of law is still Tyranny
NH Full Flow Float Valves™
Obsolete carburetor parts manufactured
-
vanco
Topic author - Posts: 22
- Joined: Wed Apr 10, 2019 5:58 pm
- First Name: John
- Last Name: Van Cott
- Location: Utah
Re: Valve Lifters
Just a very slight side to side movement, but not all have it. Mostly tight but one or two have very slight movement.