- 474627s.jpg (2.23 KiB) Viewed 691 times
- 101s.jpg (2.68 KiB) Viewed 691 times
Rear axle question
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
DHort
Topic author - Posts: 2826
- Joined: Sun Jan 06, 2019 1:30 pm
- First Name: Dave
- Last Name: Hjortnaes
- * REQUIRED* Type and Year of Model Ts owned: 24 Speedster, 20 touring
- Location: Men Falls, WI
Rear axle question
If you are installing the old axle seal you will use the steel washer outbound of the hyatt bearing.
If you are using the modern axle seal with o rings, do you still install the steel washer?
-
JohnH
- Posts: 367
- Joined: Sun Jan 06, 2019 6:57 pm
- First Name: John
- Last Name: Hunter
- * REQUIRED* Type and Year of Model Ts owned: 1926 Geelong Tourer
- Location: Blue Mountains, Australia
- Board Member Since: 2002
- Contact:
Re: Rear axle question
No, the steel washer is not used. It keeps the bearing and felt in position for the original type seal. The modern seal keeps the bearing in position by itself.