I have a brass L-4 Kingston that needs new plates & shafts. The shafts where made from copper tubing & the plates made from body washers.
I see from the parts books that the throttle & choke are the same part #. This throttle plate is 1.060" but the choke plate is 1.125". Are the NH
plates 1.125" ? I don't seem to have a NH in all of my carbs. Thanks guys.
Craig.
Carb question
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Craig Leach
Topic author - Posts: 1906
- Joined: Tue Jan 08, 2019 12:22 am
- First Name: craig
- Last Name: leach
- * REQUIRED* Type and Year of Model Ts owned: 1919 Firetruck/1922 Speedster
- Location: Laveen Az
-
Corey Walker
- Posts: 637
- Joined: Sun Jan 06, 2019 11:46 am
- First Name: Corey
- Last Name: Walker
- * REQUIRED* Type and Year of Model Ts owned: 1914 runabout, 1921 homemade truck, 1921 Speedster
- Location: Brownsboro, TX
- Board Member Since: 2007
Re: Carb question
You can use an NH throttle shaft and plate in an L4. Brass one uses the long arms. The choke shaft is larger diameter and the lever part is different, choke plate is larger.
Corey Walker, Brownsboro, Texas