So I just got a 13 tooth pinion stamped with Ruckstell, 8501 13-40 20N on the front and LC.CO. ID24 along with another number that can't be read on the back.
Would this have been used with the standard 40 tooth ring gear or other? With 40 tooth, looks to be about 3.07 to 1. How common was this combination, I don't see a lot in the Ruckstell repair book from the club.
Ruckstell 13 tooth pinion gear
Forum rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
If you need help logging in, or have question about how something works, use the Support forum located here Support Forum
Complete set of Forum Rules Forum Rules
-
Mark Gregush
Topic author - Posts: 5370
- Joined: Sat Jan 05, 2019 1:57 pm
- First Name: Mark
- Last Name: Gregush
- * REQUIRED* Type and Year of Model Ts owned: 1925 cutdown PU, 1948 F2 Ford flat head 6 pickup 3 speed
- Location: Portland Or
- Board Member Since: 1999
Ruckstell 13 tooth pinion gear
I know the voices aren't real but damn they have some good ideas! 
1925 Cut down pickup
1948 Ford F2 pickup
1925 Cut down pickup
1948 Ford F2 pickup
-
speedytinc
- Posts: 4726
- Joined: Fri Feb 12, 2021 12:24 pm
- First Name: john
- Last Name: karvaly
- * REQUIRED* Type and Year of Model Ts owned: 14/15 wide track roadster. 23 touring, 27 roadster pickup, 20ish rajo touring
- Location: orange, ca
- Board Member Since: 2020
Re: Ruckstell 13 tooth pinion gear
It goes with a rux ring gear. That gear has the offset you see in the 13-39 gear sets. No, it wont fit a stock ford 40 T gear.
-
Mark Gregush
Topic author - Posts: 5370
- Joined: Sat Jan 05, 2019 1:57 pm
- First Name: Mark
- Last Name: Gregush
- * REQUIRED* Type and Year of Model Ts owned: 1925 cutdown PU, 1948 F2 Ford flat head 6 pickup 3 speed
- Location: Portland Or
- Board Member Since: 1999
Re: Ruckstell 13 tooth pinion gear
Ok, buggers! Thanks
I know the voices aren't real but damn they have some good ideas!
1925 Cut down pickup
1948 Ford F2 pickup
1925 Cut down pickup
1948 Ford F2 pickup
-
Wayne Sheldon
- Posts: 4249
- Joined: Sun Jan 06, 2019 3:13 pm
- First Name: Wayne
- Last Name: Sheldon
- * REQUIRED* Type and Year of Model Ts owned: 1915 Runabout 1913 Speedster
- Location: Grass Valley California, USA
- Board Member Since: 2005
Re: Ruckstell 13 tooth pinion gear
Before a thousand 13/39 gears were made post WW2, those were the usual "3 to 1" gears. Yes, they are not exactly 3 to 1, but that was what people called them. There were also some other companies back in the era that made 13/40, 13/39, 13/36, ten tooth pinions, and even a couple other unusual ratios.
The Ruckstell 13/40 gears were fairly good, but they sometimes had hardening issues resulting in a few teeth sometimes breaking on the outer ends.
The Ruckstell 13/40 gears were fairly good, but they sometimes had hardening issues resulting in a few teeth sometimes breaking on the outer ends.