WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
-
JTT3
Topic author - Posts: 1865
- Joined: Sun Jan 06, 2019 11:57 am
- First Name: John
- Last Name: Tannehill
- Location: Hot Coffee, MS
WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Header says it all. Best John
-
RGould1910
- Posts: 1142
- Joined: Tue Jan 22, 2019 8:16 am
- First Name: Richard
- Last Name: Gould
- * REQUIRED* Type and Year of Model Ts owned: 1910 touring, 1912 roadster , 1927 roadster
- Location: Folsom, CA
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
John, I wonder if you might make one as I did from a 13-14 riveted drag link. Cut off the ends, drill and ream them out, then tap them for the threaded rod. The rod is the easiest part to make.
I found the difficult part was tapping the threads straight but it was all doable.
I found the difficult part was tapping the threads straight but it was all doable.
-
JTT3
Topic author - Posts: 1865
- Joined: Sun Jan 06, 2019 11:57 am
- First Name: John
- Last Name: Tannehill
- Location: Hot Coffee, MS
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
Richard it may come to that. Thanks for the potential solve.
Best John
Best John
-
Ken Buhler
- Posts: 525
- Joined: Mon Jan 21, 2019 4:14 pm
- First Name: Ken
- Last Name: Buhler
- * REQUIRED* Type and Year of Model Ts owned: 1927 Roadster 1927 Coupe
- Location: Kelowna B.C.
- Board Member Since: 2012
Re: WANTED, 1909/10 Fine thread drag link & tie rod or end parts to assemble
I may have some of those if they have threads at both ends.
Work honestly
Stay true to your word
Get the job done right
Stay true to your word
Get the job done right