Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube

Post by **Mark Herdman** » Thu Sep 12, 2024 11:54 pm

Wanted

Rajo B,BB,BBR single inlet updraft manifold with water tube as in this photo to rebuild this Australian original race car to its 1925 form. Any help appreciated.

Post by **Mark Herdman** » Sat Jan 10, 2026 1:03 am

Still looking for one of these inlet manifolds to fit a B BB BBR Rajo if anyone has one. Thanks for Mark Chaffin for the use of this photo. Same as the one on my car in the above photo taken of the car in 1925.

Post by **Henry K. Lee** » Sat Jan 10, 2026 5:57 am

Would not be difficult to fabricate one and then texture to look like cast aluminum. Been there done that.

Post by **Mark Herdman** » Sat Jan 10, 2026 10:07 pm

Henry K. Lee wrote: ↑
Sat Jan 10, 2026 5:57 am
Would not be difficult to fabricate one and then texture to look like cast aluminum. Been there done that.

Thanks for the advice Henry

MTFCA Forum

Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube

Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube

Re: Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube

Re: Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube

Re: Wanted Rajo B,BB,BBR single inlet updraft manifold with water tube