Bearing surface - 1.1875
Center mark - 2 3/8" X 2 1/8 from end
Overall length - 4.4315 mm
Bushing holes - .637 mm
Arm bushing length - 1"
Price is $250 plus shipping unless I am convinced it is too much, as I am open to educated opinions.
SOLD One Piece Spindle
-
Ken Buhler
Topic author - Posts: 524
- Joined: Mon Jan 21, 2019 4:14 pm
- First Name: Ken
- Last Name: Buhler
- * REQUIRED* Type and Year of Model Ts owned: 1927 Roadster 1927 Coupe
- Location: Kelowna B.C.
- Board Member Since: 2012
SOLD One Piece Spindle
This has a faint part number 203 and may have an A following. It is in very good overall condition. There is evidence of some brass, probably from fitting a bushing as one hole shows a slight squeeze. The measurements are as below.
Bearing surface - 1.1875
Center mark - 2 3/8" X 2 1/8 from end
Overall length - 4.4315 mm
Bushing holes - .637 mm
Arm bushing length - 1"
Price is $250 plus shipping unless I am convinced it is too much, as I am open to educated opinions.
Bearing surface - 1.1875
Center mark - 2 3/8" X 2 1/8 from end
Overall length - 4.4315 mm
Bushing holes - .637 mm
Arm bushing length - 1"
Price is $250 plus shipping unless I am convinced it is too much, as I am open to educated opinions.
Last edited by Ken Buhler on Wed Jul 30, 2025 12:31 am, edited 1 time in total.
Work honestly
Stay true to your word
Get the job done right
Stay true to your word
Get the job done right
-
kenfo15
- Posts: 10
- Joined: Tue Jan 08, 2019 1:48 am
- First Name: ken
- Last Name: foster
- Location: australia
Re: One Piece Spindle
Ken sent you a pm Ken